Sony str-k660p manual usuario

No notes for slide. After tuning in any AM station, turn off the receiver. All preset stations will be erased when you change the tuning scale.

To reset the scale to 10 kHz or 9 kHz , repeat the procedure. Power consumption during standby mode 0. Check leakage as described below. LEAKAGE The AC leakage from any exposed metal part to earth ground and from all exposed metal parts to any exposed metal part having a return to chassis, must not exceed 0.

Leakage current can be measured by any one of three methods. A battery-operated AC milliammeter. The Data Precision digital multimeter is suitable for this job. Nearly all battery operated digital multimeters that have a 2V AC range are suitable. See Fig. Using an AC voltmeter to check AC leakage. Unleaded solder Boards requiring use of unleaded solder are printed with the lead- free mark LF indicating the solder contains no lead.

Caution: Some printed circuit boards may not come printed with the lead free mark due to their particular size. Ordinary soldering irons can be used but the iron tip has to be applied to the solder joint for a slightly longer time. Caution: The printed pattern copper foil may peel away if the heated tip is applied for too long, so be careful! Parts No. H X Mmm. Press to select the unit for search track, index, etc.

Press to enter the selection. DVD player Selects track numbers. VCR Selects channel numbers. Therefore, depending on the component the above operation may not be possible or may operate differently than described. Remote Button Operations Function. VCR Fastforwards or rewinds. Also starts recording with components in recording standby. Turn off the main power. Select the desired step. When this test is activated, all segments turn on at the same time, then each segment turns on one after another.

All segments turn on. Use this mode before returning the product to clients upon completion of repair. The model name, destination and the software version are displayed.

Every pressing of any button other than? The buttons which are already counted once are not counted again. Select the desired mode. Voltage variations may be noted due to normal produc- tion tolerances. In addition to this necessary note is printed in each block. Caution: Pattern face side: Parts on the pattern face side seen from Side A the pattern face are indicated. Parts face side: Parts on the parts face side seen from Side B the parts face are indicated.

For printed wiring boards. C B These are omitted. E Q B These are omitted. Replace only with part number specified. Location Ref. Some delay should be anticipated when ordering these items. Part No. Description Remarks Ref. Description Remarks To reset the scale to 10 kHz or 9 kHz , repeat the procedure.

Check leakage as described below. The AC leakage from any exposed metal part to earth ground and from all exposed metal parts to any exposed metal part having a return to chassis, must not exceed 0. Leakage current can be measured by any one of three methods. A battery-operated AC milliammeter.

The Data Precision digital multimeter is suitable for this job. Nearly all battery operated digital multimeters that have a 2V AC range are suitable.

See Fig. AC Voltmeter 0. Using an AC voltmeter to check AC leakage. Boards requiring use of unleaded solder are printed with the lead- free mark LF indicating the solder contains no lead. Caution: Some printed circuit boards may not come printed with the lead free mark due to their particular size. Unleaded solder has the following characteristics.